Copyright This publication, including all photographs, illustrations and software, is protected under international copyright laws, with all rights r
DLP Projector—User’s Manual – 1 – GETTING STARTED Packing Checklist Carefully unpack the projector and check that the following items are included:
DLP Projector—User’s Manual Views of Projector Parts Front-right View 1234 5 ITEM LABEL DESCRIPTION SEE PAGE 1. IR receiver Receive IR signal fro
DLP Projector—User’s Manual Top view—On-screen Display (OSD) buttons and LEDs 12345678 ITEM LABEL DESCRIPTION SEE PAGE1. Keystone Navigates and
DLP Projector—User’s Manual Rear view Warning: As a safety precaution, disconnect all power to the projector and connecting devices before making con
DLP Projector—User’s Manual Bottom view 121122 ITEM LABEL DESCRIPTION SEE PAGE 1. Ceiling support holes Contact your dealer for information on mo
DLP Projector—User’s Manual Remote Control Parts 123456789101112131415Menu PowerVolumeFreezeAutoSource Mute ITEM LABEL DESCRIPTION SEE PAGE 1. Up
DLP Projector—User’s Manual Inserting the Remote Control Batteries 1. Remove the battery compartment cover by sliding the cover in the direction of
DLP Projector—User’s Manual — 8 — Important: 1. Avoid using the projector with bright fluorescent lighting turned on. Certain high-frequency fluoresce
DLP Projector—User’s Manual – 9 – SETUP AND OPERATION Starting and Shutting down the Projector 1. Connect the power cord to the projector. Connect t
DLP Projector—User’s Manual 5.When the “Power Off? /Press Poweragain” message appears, press thePOWER button. The projector turnsoff.Caution: Do not u
DLP Projector—User’s Manual — ii — Important Safety Information Important: It is strongly recommended that you read this section carefully before usin
DLP Projector—User’s Manual Setting an Access Password (Security Lock) You can use the four (arrow) buttons to set a password and prevent unauthorized
DLP Projector—User’s Manual 5. You can use the cursor buttons ▲▼◄► either on keypad or IR remote control for password entry. You can use any combinat
DLP Projector—User’s Manual Adjusting the Projector Level Take note of the following when setting up the projector: The projector table or stand sh
DLP Projector—User’s Manual Adjusting the Zoom, Focus and Keystone 1. Use the Image-zoom control (on the projector only) to resize the projected ima
DLP Projector—User’s Manual – 15 – ON-SCREEN DISPLAY (OSD) MENU SETTINGS OSD Menu Controls The projector has an OSD that lets you make image adjustmen
DLP Projector—User’s Manual Setting the OSD Language Set the OSD language to your preference before continuing. 1. Press the MENU button. Press the c
DLP Projector—User’s Manual OSD Menu Overview Use the following illustration to quickly find a setting or determine the range for a setting. ImageSett
DLP Projector—User’s Manual Image Menu Attention ! All of display mode parameters when changed will be saved to user mode. Press the MENU button t
DLP Projector—User’s Manual Computer Menu Press the MENU button to open the OSD menu. Press ◄► to move to the Image menu. Press ▲▼ to move to the Comp
DLP Projector—User’s Manual Advanced Feature Press the Menu button to open the OSD menu. Press ◄► to move to the Image menu. Press ▼▲ to move to the A
Preface Projector Installation Notice Place the projector in a horizontal position The tilt angle of the projector should not exceed 15 degrees, no
DLP Projector—User’s Manual Color Manager Press the Menu button to open the OSD menu. Press ◄► to move to the Image menu. Press ▼▲ to move to the Colo
DLP Projector—User’s Manual Settings 1 Menu Press the MENU button to open the OSD menu. Press the cursor ◄► button to move to the Settings 1 menu. Pr
DLP Projector—User’s Manual Audio Press the Menu button to open the OSD menu. Press ◄► to move to the Settings 1 menu. Press ▼▲ to move to the Audio m
DLP Projector—User’s Manual Advanced 1 Feature Press the Menu button to open the OSD menu. Press ◄► to move to the Settings 1 menu. Press ▲▼ to move t
DLP Projector—User’s Manual 3D Setting ITEM DESCRIPTION 3D Press the cursor ◄► button to enter and select different 3D mode. 3D Sync Invert Press
DLP Projector—User’s Manual Advanced 2 Feature Press the Menu button to open the OSD menu. Press ◄► to move to the Settings 1 menu. Press ▲▼ to move t
DLP Projector—User’s Manual Settings 2 Menu Press the MENU button to open the OSD menu. Press the cursor ◄► button to move to the Settings 2 menu. Pr
DLP Projector—User’s Manual Status Press the cursor ▲▼ button to move up and down in the Settings 2 menu. Select the Status menu and press Enter or ►
DLP Projector—User’s Manual Advanced 1 Feature Press the Menu button to open the OSD menu. Press ◄► to move to the Settings 2 menu. Press ▲▼ to move t
DLP Projector—User’s Manual Lamp Hour Reset Please refer to Resetting the Lamp on page 36 to reset the lamp hour counter. — 30 —
DLP Projector—User’s Manual — iv — Verify Installation Location To supply power, the 3-blade (with earthing lead) socket should be used to ensure p
DLP Projector—User’s Manual Advanced 2 Feature Press the Menu button to open the OSD menu. Press ◄► to move to the Settings 2 menu. Press ▲▼ to move t
DLP Projector—User’s Manual Source Filter Press the ENTER button to enter the Source Filter sub menu. ITEM DESCRIPTION VGA1 Press the ◄► buttons to
DLP Projector—User’s Manual – 33 – MAINTENANCE AND SECURITY Replacing the Projection Lamp The projection lamp should be replaced when it burns out. It
DLP Projector—User’s Manual 2. Remove the lamp compartment cover. 3. Disconnect the lamp connector 12 4. Remove the two screws from the lamp modu
DLP Projector—User’s Manual 7. Reverse steps 1 to 6 to install the new lamp module. While installing, align the lamp module and ensure it is level
DLP Projector—User’s Manual Resetting the Lamp After replacing the lamp, you should reset the lamp hour counter to zero. Refer to the following: 1. P
DLP Projector—User’s Manual – 37 – Cleaning the Projector Cleaning the projector to remove dust and grime will help ensure trouble-free operation. Wa
DLP Projector—User’s Manual Using the Kensington® Lock & Using the Security Bar Using the Kensington® Lock If you are concerned about security, a
DLP Projector—User’s Manual – 39 – TROUBLESHOOTING Common problems and solutions These guidelines provide tips to deal with problems you may encounter
DLP Projector—User’s Manual — 40 — LED Error Messages ERROR CODE MESSAGES POWER LED BLUE LAMP LED RED System Initial Flash OFF Ready to Power on (Stan
Preface –v – Choosing a Projector Edge blending application Not only brightness, bright balances, lens but stability is important too when choosing
DLP Projector—User’s Manual – 41 – Problem: The image is reversed Check the Projection setting on the Settings 1 menu of the OSD. Problem: The image
DLP Projector—User’s Manual — 42 — 5. Have the projector serviced. Problem: The sound is distorted 1. Check the audio cable connection. 2. Test th
DLP Projector—User’s Manual – 43 – HDMI Q & A Q. What is the difference between a “Standard” HDMI cable and a “High-Speed” HDMI cable? Recently, H
DLP Projector—User’s Manual — 44 — SPECIFICATIONS Specifications Model D550 / D552 D55BA D556 / D554 Display type TI DMD 0.55” SVGA Resolution SVGA
DLP Projector—User’s Manual – 45 – Model D548 / D54HA D551 D553 D555 Display type TI DMD 0.55” SVGA TI DMD 0.55” XGA Resolution SVGA 800x600 XGA
DLP Projector—User’s Manual — 46 — Model D557W / D557WH D560ST Display type TI DMD 0.65” WXGA TI DMD 0.55” SVGA Resolution WXGA 1280 x 800 SVGA 800
DLP Projector—User’s Manual Projection Distance vs. Projection Size Projection Distance and Size Table D550 / D552 / D556 / D548 / D54HA / D551 /D553
DLP Projector—User’s Manual — 48 — D557W / D557WH IMAGE DIAGONAL (INCH)IMAGE WIDTH (INCH) IMAGE HIGHT (INCH) PROJECTIONDISTANCE (MM) FROM PROJECTIOND
DLP Projector—User’s Manual – 49 – Timing Mode Table SIGNAL RESOLUTION H-SYNC (KHZ) V-SYNC (HZ) COMPOSITE / S-VIDEOCOMPONENT RGB DVI/ HDMI NTSC - 1
DLP Projector—User’s Manual — 50 — SIGNAL RESOLUTION H-SYNC (KHZ) V-SYNC (HZ) COMPOSITE / S-VIDEOCOMPONENT RGB DVI/ HDMI 1280 x 960 60.0 60.0 -
DLP Projector—User’s Manual Power Safety Only use the supplied power cord. Do not place anything on the power cord. Place the power cord where i
DLP Projector—User’s Manual Projector Dimensions 274.6mm[10.8"]212mm[9.346"]100.3mm[3.95"]86mm[3.386"] – 51 –
DLP Projector—User’s Manual — 52 — REGULATORY COMPLIANCE FCC Warning This equipment has been tested and found to comply with the limits for a Class B
DLP Projector—User’s Manual – 53 – APPENDIX I RS-232C Protocol RS232 Setting Baud rate: 9600 Parity check: None Data bit: 8 Stop bit: 1 Flow Contro
DLP Projector—User’s Manual — 54 — Command Group 01 ASCII HEX Function Description Return ValueVXXG0101 56h Xh Xh 47h 30h 31h 30h 31h 0Dh Get Brig
DLP Projector—User’s Manual – 55 – Command Group 03 ASCII HEX Function Description Return Value VXXG0301 56h Xh Xh 47h 30h 33h 30h 31h 0Dh Get Scal
DLP Projector—User’s Manual — 56 — Command Group 04 (Remote Control) ASCII HEX Function Description Return ValueVXXS0401 56h Xh Xh 53h 30h 34h 30h 3
Preface –vii – Main Features Lightweight unit, easy to pack away and transport. Compatible with all major video standards including NTSC, PAL, a
DLP Projector—User’s Manual — viii — Table of Contents GETTING STARTED......
Preface –ix – SPECIFICATIONS..............................
Kommentare zu diesen Handbüchern