Vivitek D5280U Bedienungsanleitung

User’s ManualD5280U

DLP Projector—User’s Manual Views of Projector Parts Front-right View ITEM LABEL DESCRIPTION SEE PAGE: 1. IR receiver Receives IR signal from r

PPPrrreeefffaaaccceee Top view—On-screen Display (OSD) buttons and LEDs ITEM LABEL DESCRIPTION SEE PAGE: 1. MENU Opens and exits OSD menus 2.

DLP Projector—User’s Manual Rear view D ITEM LABEL DESCRIPTION SEE PAGE: 1. VGA1 IN Connect a RGB cable from a computer or a video enabled device

PPPrrreeefffaaaccceee – 5 – ITEM LABEL DESCRIPTION SEE PAGE: 15. 12V When connected to the screen through a commercially available cable, the s

DLP Projector—User’s Manual Bottom view ITEM LABEL DESCRIPTION SEE PAGE: 1. Tilt adjustor Rotate adjuster lever to adjust angle position. 15 2

PPPrrreeefffaaaccceee Remote Control Parts Important: 1. Avoid using the projector with bright fluorescent lighting turned on. Certain high-frequ

DLP Projector—User’s Manual — 8 — ITEM LABEL DESCRIPTION SEE PAGE: 1. Power OFF Turns the projector off 13 2. BNC Displays the BNC source sele

PPPrrreeefffaaaccceee – 9 – Remote Control Operating Range The remote control uses infrared transmission to control the projector. It is not necess

DLP Projector—User’s Manual — 10 — SETUP AND OPERATION Inserting the Remote Control Batteries 1. Remove the battery compartment cover by sliding the

PPPrrreeefffaaaccceee Installing or Removing the Optional Lens Caution: y Do not shake or place excessive pressure on the projector or the lens com

3Copyright This publication, including all photographs, illustrations and software, is protected under international copy-right laws, with all rights

DLP Projector—User’s Manual Installing the New Lens 1. Align the notches and correctly position the electrical contact pad as shown in the picture. N

PPPrrreeefffaaaccceee Starting and Shutting down the Projector 1. Remove the lens cap. 2. Securely connect the power cord and signal cable. When

DLP Projector—User’s Manual 4. If more than one input device is con-nected, press the SOURCE button and use ▲▼ to scroll among devices. (Component is

PPPrrreeefffaaaccceee Adjusting the Projector Level Take note of the following when setting up the projector: • The projector table or stand shoul

DLP Projector—User’s Manual Adjusting Projected Image Position Using Shift The Shift feature provides a lens shift function that can be used to adjus

PPPrrreeefffaaaccceee Adjusting the horizontal image position With the lens in the center position the horizontal image position can be adjusted to

DLP Projector—User’s Manual Adjusting the Zoom, Focus and Keystone 1. Use the Image-zoom control (on the projector only) to resize the pro-jected im

PPPrrreeefffaaaccceee Adjusting the Volume 1. Press the Volume +/- buttons on the remote control. The volume control appears on the display. 2.

DLP Projector—User’s Manual — 20 — ON-SCREEN DISPLAY (OSD) MENU SETTINGS OSD Menu Controls The projector has an OSD that lets you make image adjustmen

PPPrrreeefffaaaccceee Setting the OSD Language Set the OSD language to your preference before continuing. 1. Press the MENU button. Press the curs

DLP Projector—User’s Manual — ii — Important Safety Information Important: It is strongly recommended that you read this section carefully before usin

DLP Projector—User’s Manual OSD Menu Overview Use the following illustration to quickly find a setting or determine the range for a setting. PICTURE&g

PPPrrreeefffaaaccceee PICTURE>>Basic Menu Press the MENU button to open the OSD menu. Press the cursor ◄► button to move to the PICTURE>&g

DLP Projector—User’s Manual PICTURE>>Advanced Menu Press the MENU button to open the OSD menu. Press the cursor ◄► button to move to the PICTUR

PPPrrreeefffaaaccceee HSG Adjustment Press the ENTER button to enter the HSG Adjustment sub menu. ITEM DESCRIPTION Primary Color Press the ◄► bu

DLP Projector—User’s Manual DISPLAY Menu Press the MENU button to open the OSD menu. Press the cursor ◄► button to move to the DISPLAY menu. Press th

PPPrrreeefffaaaccceee PC Detail Adjustment Press the ENTER button to enter the PC Detail Adjustment sub menu. Note: Customizing the settings in PC

DLP Projector—User’s Manual SETUP>>Basic Menu Press the MENU button to open the OSD menu. Press the cursor ◄► button to move to the SETUP>&

PPPrrreeefffaaaccceee Menu Settings Press the ENTER button to enter the Menu Settings sub menu. ITEM DESCRIPTION Menu Position Press the ◄► butto

DLP Projector—User’s Manual Command Control Settings Press the ENTER button to enter the Command Control Settings sub menu. ITEM DESCRIPTION Control

PPPrrreeefffaaaccceee For simplicity and ease of operation, the projector provides diverse networking and remote management features. The LAN/RJ45

PPPrrreeefffaaaccceee Projector Installation Notice ¾ Place the projector in a horizontal position The tilt angle of the projector should not exce

DLP Projector—User’s Manual 3. Right-click on Local Area Connection, and select Properties. 4. In the Properties window, select the General tab, and

PPPrrreeefffaaaccceee 7. Press the Menu button on the projector. 8. Select SETUP>>Basic Menu →Command Control Settings→Network State. 9. Af

DLP Projector—User’s Manual SETUP>>Advanced Menu Press the MENU button to open the OSD menu. Press the cursor ◄► button to move to the SETUP>

PPPrrreeefffaaaccceee Audio Press the ENTER button to enter the Audio sub menu. ITEM DESCRIPTION Volume Press the ◄► buttons to adjust the audio

DLP Projector—User’s Manual HDMI Press the ENTER button to enter the HDMI sub menu. ITEM DESCRIPTION HDMI Format Press the ◄► buttons to select from

PPPrrreeefffaaaccceee Presentation Timer The Presentation Timer function can indicate the presentation time on the screen to help you achieve bette

DLP Projector—User’s Manual STATUS Menu Press the MENU button to open the OSD menu. Press the cursor ◄► button to move to the STATUS Menu. ITEM DE

PPPrrreeefffaaaccceee – 39 – MAINTENANCE AND SECURITY Replacing the Projection Lamp The projection lamp should be replaced when it burns out. It sh

DLP Projector—User’s Manual 4. Unlock the lamp cover. 5. Pull up and remove the cover. 6. Use a screwdriver to remove the screws from the lamp mod

PPPrrreeefffaaaccceee 8. Reverse steps 1 to 7 to install the new lamp module. While installing, align the lamp module with the connector and ensu

DLP Projector—User’s Manual Power Safety ¾ Only use the supplied power cord. ¾ Do not place anything on the power cord. Place the power cord where i

DLP Projector—User’s Manual — 42 — Cleaning the Projector Cleaning the projector to remove dust and grime will help ensure trouble-free operation. Wa

PPPrrreeefffaaaccceee Using the Physical Lock Using the Kensington® Lock If you are concerned about security, attach the projector to a permanent o

DLP Projector—User’s Manual — 44 — TROUBLESHOOTING Common problems and solutions These guidelines provide tips to deal with problems you may encounter

PPPrrreeefffaaaccceee – 45 – LED Error Messages POWER LED READY LED TEMP LED ERROR CODE MESSAGES Green Red Red Red Lamp Ready ON － ON － Start

DLP Projector—User’s Manual — 46 — Problem: The color of the projected image does not match the source image. Adjust the Color Temperature and Gamma s

PPPrrreeefffaaaccceee – 47 – HDMI Q & A Q. What is the difference between a “Standard” HDMI cable and a “High-Speed” HDMI cable? Recently, HDMI

DLP Projector—User’s Manual — 48 — SPECIFICATIONS Specifications Display type 0.67" WUXGA DC3 Resolution WUXGA 1920x1200 Native Projection dista

PPPrrreeefffaaaccceee Projection Distance vs. Projection Size (WUXGA)  V-Sync Projection DistanceHHOImage HightA Projection Distance and Size Ta

DLP Projector—User’s Manual — 50 — Short throw projection lesn: TR: 0.77; offset=110% FIX Distance (m) 0.66 1.33 1.66 2.49 Diagonal (") 40 80

PPPrrreeefffaaaccceee – 51 – Timing Mode Table SIGNAL RESOLUTION H-SYNC (KHZ) V-SYNC(HZ) COMPOSITE /S-VIDEO VGA 1/2(ANALOG)BNC HDMI (DIGITAL)DP (

PPPrrreeefffaaaccceee – v – Main Features • Lightweight unit, easy to pack away and transport. • Compatible with all major video standards includ

DLP Projector—User’s Manual — 52 — SIGNAL RESOLUTION H-SYNC (KHZ) V-SYNC(HZ) COMPOSITE /S-VIDEO VGA 1/2(ANALOG)BNC HDMI (DIGITAL)DP (DIGITAL)720p 37

PPPrrreeefffaaaccceee Projector Dimensions – 53 –

DLP Projector—User’s Manual — 54 — REGULATORY COMPLIANCE FCC Warning This equipment has been tested and found to comply with the limits for a Class B

PPPrrreeefffaaaccceee – 55 – APPENDIX I RS-232C Protocol RS232 Setting Baud rate: 9600 Parity check: None Data bit: 8 Stop bit: 1 Flow Control

DLP Projector—User’s Manual — 56 — Command Group 01 ASCII HEX Function Description Return ValueVXXG0101 56h Xh Xh 47h 30h 31h 30h 31h 0Dh Get

PPPrrreeefffaaaccceee – 57 – Command Group 02 ASCII HEX Function Description Return ValueVXXS0211 56h Xh Xh 53h 30h 32h 31h 31h 0Dh Select DP

DLP Projector—User’s Manual — 58 — Command Group 03 ASCII HEX Function Description Return ValueVXXG0309 56h Xh Xh 47h 30h 33h 30h 39h 0Dh Set ver

DLP Projector—User’s Manual — vi — Table of Contents GETTING STARTED...

PPPrrreeefffaaaccceee – vii – LED ERROR MESSAGES.......

DLP Projector – User’s Manual — 1 — GETTING STARTED Packing Checklist Carefully unpack the projector and check that the following items are included: